Spelsberg Wallbox Smart Pro

← Chargers Sponsor token required

The 'Modbus TCP Server' must be enabled. The setting 'Register Address Set' must NOT be set to 'Phoenix' or 'TQ-DM100'. Use the third selection labeled 'Ebee', 'Bender', 'MENNEKES' etc. Set 'Allow UID Disclose' to On.

Firmware 5.33 or higher is required for phase switching. The 'SEMP interface' must be enabled, the 'SEMP Charging Mode' must be set to 'Surplus Charging'. Set 'Software function to use phase switching' to SEMP.

Supported features

RFID: Integrated RFID card reader for vehicle identification.
1P/3P: Automatic phase switching. Useful for solar surplus charging.

Parameters

Name	Description	Value	Level
`id`	Modbus ID Default: `1`	int	required
`host`	IP address or hostname Example: `192.0.2.2`		required
`port`	Port Default: `502`	int	required

Configuration example for evcc.yaml

If you don't want to configure via the UI, you can alternatively use this YAML block.

chargers:
    - name: my_charger
      type: template
      template: bender-cc

      # Modbus TCP
      modbus: tcpip
      id: 255
      host:  # Hostname
      port: 502 # Port